How to install a vinyl decal
How to apply a vinyl decal:
Step 1

Clean the area thoroughly with rubbing alcohol or soap and water. Do not use Windex or similar
Step 2
Prepare the decal for application by firmly rubbing a squeegee or credit card across the clear
transfer tape. This removes any air bubbles that may have formed and makes the sticker cling
to the transfer tape.
Step 3
Peel the white paper backing off the decal. If the decal clings to the backing, slowly replace the
paper backing and repeat Step 2.
Step 4
Slowly lower the decal onto the surface and rub it in place firmly with a squeegee or credit card.
For best results, wait a few minutes before moving to the next step.
Step 5
Slowly peel the clear transfer tape off at an angle. Be careful not to pull the decal off the surface.
If the decal pulls away from the surface repeat Step 4.
*Use a pin to poke any air bubbles in the center and push the air out through the hole.
*For best results do not apply a sticker/decal in extreme hot or cold temperatures.
Your shopping cart is empty!